Side Corner Assembly

side corner assembly with detailed view for 3D printer enclosure

Side Panel Assembly

side view of universal enclosure side assembly
detailed view of side assembly of 3d printer enclosure
detailed view of rubber pad installation for 3d printer enclosure feet

Pro Tip for Reaching the Last Nuts

When you begin assembling the walls, the last nuts can be tricky to reach. We recommend assembling the enclosure on the table where you intend to leave the enclosure as it is somewhat difficult to move around due to the size. When you get to the final few nuts (especially on the last set of feet), position the corner of the enclosure where it hangs slightly off the edge of the table in order to reach the nuts as shown below.

tip for adding final nuts to 3d printer enclosure