FILAMENT HOLDER ASSEMBLY GUIDE
(included in Universal 3D Printer Enclosure kit)
x2 608 bearings
We’ve made a filament holder that goes well with the design of the enclosure. You will need to print 4 pieces for each set of holders (2 per side). The pieces will press-fit into the bearings.
We’ve also provided a “modifier” part where you can get creative with Prusa slicer. To use the modifier, import the filament holder STL and right-click. Navigate to Add Modifier -> Load ... The modifier should load into the part as shown below. Make sure that the part is oriented with the outside surface facing down (as shown below).
Right-click on the gear next to Modifier.stl on in the right panel. Select Layers and Perimeters -> set Bottom, Perimeters and Top to 0
Right-click on the gear beside Modifier.stl again. Select Infill -> set Fill Density to 40% and Fill pattern to Honeycomb
Click Slice now