Place the cable attached to the LED strip into the cable channel (1) as you begin to rotate the switch into position (2).; as you rotate the switch into place, make sure that the cable coming out of the enclosure is going i the bottom cable channel (3)

Once the cables are in position, push this side all the way into place - you may need to gently pull on the cables entering and exiting the part to get it perfectly into position

Now, the LED switch should be fully installed

Step #3: Layout the Smaller LED Insert Parts

Layout the parts as shown below

Step #4: Layout the LED Parts

Place the LED Light with Rear Mount onto into place and feed the LED Light Strip through the channel (following the path of the arrows)

Step #5: Add LED Cover Parts

Add the LED Cover pieces shown below - there are slots that must align to fit properly

Step #6: Add the Remaining LED Cover Parts

Place the remaining covers into position

Step #7: Add the Remaining LED Cover Parts

Insert the 2 nuts into the slots - make sure they are pushed all the way to the bottom of the hole

Step #8: Add Nuts to the Rear Mounting Piece (OPTIONAL)

If you would like to anchor your LED Enclosure to the back wall of the enclosure, add 2 nuts to the back piece as shown***This will require you to remove these bolts prior to removing the top which reduces accessibility. We generally recommend skipping this step unless you are confident that you will not need to remove the top of the enclosure.***

Step #9: Add the Top Plexiglass

Place the top plexiglass piece beneath the LED light and align the holes

Step #10: Slide to Edge of Table

Carefully slide the plexiglass to the edge of the table so that you can attach the LED Light - you may want to temporarily add something heavy like a spare filament roll to the end still on the table