DELACK for A1 Mini Assembly Guide

#1 - Riser and Tank Assembly

Step #1: Print Off Plates #1 - #4

From the print files, make sure you have the first 4 prints completed:

1 - FEET + TOP CORNERS + SIDE CORNERS

2 - SKIRT (with or without AMS depending on your setup)

3 - TANK

4 - CLIPS

Step #2: Add Rubber Feet

Find the 4 Feet prints and add the rubber plugs to the bottom of all 4 pieces - make sure the flat part of the blue is oriented down as the foot

Step #3: Add the Corner Riser Side Pieces

Find the 8 riser pieces that are the same length (these pieces are the middle length ones - not the shortest or the longest) and insert them into each corner piece using the clips

Step #4: Add the Front and Back Riser Pieces

Find the 2 longest skirt pieces - the one with the gap goes in the back for the power cable to pass through and the solid one goes in the front

Step #5: Finish the Right Wall

Find the 2 smallest pieces that are not used for the tank - they will either be solid (for non-AMS builds) or have a small gap (for AMS builds so that the AMS cable can reach the printer) - add these pieces to the right side

No AMS Version

With AMS

Step #6: Assemble Tank Guide

In the last gap on the riser, add the tank guide pieces - BE CAREFUL AS THESE CAN ONLY GO ON ONE WAY (SEE IMAGES)

Now, add the rail guide piece on top - this should fit flush on the inside if you did the previous step correctly with a small gap on the outside

Step #7: Complete the Tank

Add the friction fit oval slot and clip to the two halves of the tank to finish assembly - the tank should fit flush with the walls

Step 8: Add the Nuts to the Feet

Finish off the Riser by adding x2 nuts to all of the feet

Riser is done!