DC Middle Assembly
After printing the DC parts, begin by assembling the center plexiglass wall by combining 2 sheets of plexiglass using 2 WASHERS, 1 BOLT, and 1 NUT for each side hole at all 4 hole locations.
*Occasionally there are small variations in plexiglass cuts that create imperfections in the hole alignment which prevents this step from occurring. That is OKAY! As long as the other pieces fit together, the enclosure will be sturdy even without these extra screws. You can try to mix and match the side sheets as the two that are packaged together typically have similar cuts if your initial attempt isn’t successful. The variations are usually very small, so the majority of the pieces should fit together without any issues.
