Back Bottom Wire Cover Selection

The default wire cover is the BACK BOTTOM WIRE COVER SINGLE, made for the power cable of the Prusa 3D printer - it fits snugly around the wire, centering it in the middle of the cutout while still allowing you to remove the enclosure from around the printer without unplugging the printer.

BACK BOTTOM WIRE COVER SINGLE

back bottom air cover single for delack 3d printer enclosure

 

For anyone who might add additional wires, you can pick from any of the 3 alternative wire covers for various alternative configurations. Another option is to leave the back cutout open, without a wire cover, if you would prefer the maximum amount of space for cables.

 

BACK BOTTOM WIRE COVER MULTI - STACKED

delack multi stack wire back cover for 3d printer enclosure

BACK BOTTOM WIRE COVER MULTI - WIDE

multi wide wire cover for delack 3d printer enclosure

BOTTOM WIRE COVER OPEN

open wire cover for delack 3d printer enclosure