SUMO/DELACK REAR FAN + DUCT ASSEMBLY GUIDE

WARNING: THIS PRINT IS DESIGNED SOLELY FOR ADDING BOTH THE FAN & DUCT TO THE BACK OF THE ENCLOSURE. THERE IS ANOTHER VERSION OF THIS FILE FOR AN ALTERNATIVE SETUP. 

CLICK HERE TO SEE THE STANDARD DUCT MOUNT

PARTS REQUIRED

FAN: Noctura NF-P12 Redux-1700 PWM

Price: $15.95

Most other 120mm fans should work with our design as long as the hole location and dimensions are the same as this fan. The screw holes MUST be 105mm x 105mm apart to fit correctly with the precut plexiglass holes. We cannot guarantee that any other fan model works with our design.

CLICK HERE TO SEE MORE RECOMMENDED FAN ACCESSORIES

PARTS REQUIRED

x1 4" Duct

  

CLICK HERE TO PURCHASE 4" DUCT - 8 FEET LONG ($11.16)

PRINTING INSTRUCTIONS

You will need to print a full set of the FAN SPACER - we recommend using the FAN GUARD as well so that there will be no interference with the operation of the fan.

The DUCT MOUNT FOR FAN SPACER.stl is different than the regular DUCT MOUNT, so you will need to reprint this part if you are upgrading from the other HEPA Mount.

ASSEMBLY

Start by placing the FAN GUARD.stl in-between the plexiglass panel and the fan as shown above. 

Add the 4 screws to hold the fan in place.

Next, combine the two spacer parts with 2 sets of fasteners.

Add 4 nuts to the inside of the spacer part (2 on both sides).

Now, add the spacer to the back plexiglass panel around the fan (which should already be attached) using x2 HOLE FILLER FOR BOLT.stl parts and x2 bolts. Make sure you have the wire slots positioned at the bottom so that the wire from the fan can exit through the part.

Now add the DUCT attachment to the back using the remaining parts and x2 bolts! Done!