SUMO/DELACK 4" DUCT ASSEMBLY GUIDE

4 inch air duct for 3d printer enclosure with ventilation

 

CLICK HERE TO DOWNLOAD FILES

PARTS REQUIRED

x1 4" Duct


4 inch duct for 3d printer enclosure ventilation system

  

CLICK HERE TO PURCHASE 4" DUCT - 8 FEET LONG ($11.16)

Begin by adding an M5x12 bolt to both of the the HOLE FILLER FOR BOLT printed parts 

hole filler for both for delack 3d printer enclosure ventilation system

 

Add x2 M5 nuts to the 4-INCH VENTILATION DUCT MOUNT

adding nuts to the delack 3d printer enclosure ventilation system duct mount

If you haven't added the 120mm fan to the enclosure, do that BEFORE the next step - the duct mount will block your access to the fan screws

ventilation system for 3d printe enclosure

LINK TO DELACK 120MM FAN ASSEMBLY GUIDE

 Add the 4-INCH VENTILATION DUCT MOUNT print to the DELACK Enclosure using x2 M5x12 bolts and the nuts prepared earlier - the duct itself should fit around the outside as well as the duct clamps that are included with the purchase of the recommended duct above

  

3d printer enclosure with ventilation system