Top Middle Support Selection
A variation of the TOP MIDDLE SUPPORT is the TOP MIDDLE SUPPORT WITH CABLE CHANNEL. This print is designed to allow for cable management if you run wires inside of the enclosure. We recommend printing 1 Top Middle Support with Wire Cutout if you plan to add the WYZE CAM MOUNT or TP-LINK MOUNT.
Additionally, if you would like to run wires out of the rear of the enclosure (WITHOUT ADDING THE LED LIGHT), consider printing the BACK TOP MIDDLE SUPPORT WITH CABLE CHANNEL.
The primary decision to make here is whether or not you would like to add the LED Light accessory print to the DELACK Enclosure.
If you DO NOT want to add the LED Light, you should print 3 TOP MIDDLE SUPPORT pieces.
If you DO want to add the LED Light, you should print 2 TOP MIDDLE SUPPORT pieces.
CLICK HERE TO VIEW THE LED ASSEMBLY GUIDE
Alternatively, you could print 1 TOP MIDDLE SUPPORT and print the DELACK HEX CROSSBEAM, which spans the top of the enclosure to add additional support. However, this print is NOT compatible with the LED Light.
