DELACK MMU3 Standard Mount

PARTS REQUIRED

x1 Prusa MMU3

  

CLICK HERE TO PURCHASE AN MMU3 FROM PRUSA ($299.99)

Before printing the Standard Mount for the MMU3, please print the DELACK SKIRT in order to raise the height of the enclosure for the Prusa MMU3.

CLICK HERE TO DOWNLOAD THE DELACK SKIRT

YOU CAN SKIP THE FOLLOWING PARTS WHEN PRINTING THE SKIRT:

x1 skirt_corner_wall

x1 skirt_side_wall

Remove these parts from the MMU3 Buffer.

Install the two MMU3 STANDARD MOUNT pieces onto the skirt as shown below

Place the MMU3 Buffer into the slots - no bolts are needed to keep the buffer in place

Once the buffer is in place, guide the PTFE tubes through the slot. We recommend placing them in the order shown below.

Your MMU3 Standard Mount is complete!