DELACK for A1 Mini Assembly Guide

#2 - Wall Assembly

Step #1: Print Off Plates #5 - #8

From the print files, make sure you have the following prints completed:

5 - LED + SIDE TOP PLATES

6 - FRONT SUPPORT + BACK COVER

7 - NAMEPLATE

8 - FAN COVER

Step #2: Add Top Corner and Middle Corner Pieces

Find the x4 Top Corner and x4 Middle Corner pieces to create the walls of the enclosure - make sure that the middle side holes are at the top of the side pieces

Step #3: Add the Front Top Support Piece

Assemble the Nameplate with the Top Support Piece

Add the piece to the front of the enclosure above the door frame

Step #4: Add the Side Top Middle Pieces

Add the two Top Middle support pieces

Step #5: Add the Back Bottom Wire Cover

Add the cover for the bottom wire gap to the back bottom of the enclosure

Step #6: Add the Fan Cover

If you don't plan to add a fan to your DELACK, you can add the fan cover now - make sure you use the Nut Spacer parts which are on the same build plate as the fan cover

Done with the walls!